Floor Boots - Plastic 35cm x 15cm

The Melbourne Vent Company

SKU: E-PFB3515-20A

Key features
Neck Size 350mm x 150mm
Spigot Sizes 200mm Angled
⌀250mm Angled
Material ABS moulded plastic
Colours available Black
Adjustable Yes, damper to adjust airflow volume
Mounting Underfloor
Suits following grilles Heating floor vent 35cm x 15cm
Related products

Floor Boots - Plastic 35cm x 15cm

Floor Boots are simply the intermediate component used for connecting the flexible ductwork to a floor vent. 

Made from injection moulded plastic, they are available in a variety of sizes and spigot configurations (such as straight, angled or side entry) to suit a differing installation requirements. Floor boots feature adjustable butterfly dampers, allowing for adjustments to the required air flow and for balancing of the system.  

Floor boot are installed under the floor with the floor vent placed inside (floor vent sits on top of the floor). The vent is then secured into place using screws of similar fixings. Ductwork is joined to the cylindrical spigot and fixed in place with either duct tape or large zip ties. Once duct and vent have been connected there should be no air leakage at either point of connection. If there does appear to be air leakage, it has likely been installed incorrectly and should be reconnected.

Only certain size combinations exist for specific vents so it is important, when considering new or replacement vents, to take note of size the ductwork to be used for the grille. Please feel free to email us at info@vents.melbourne if you need help sizing your vents.

If you have any further questions or queries, please feel free to contact us here or email directly to info@vents.melbourne